emiellr

So how big is the chance you're pulling your whole stack at once and not deploying service by service to check if it's even working properly on the new deployment?

Interesting piece. Thanks for sharing 🙏

Yeah looking back, this isn't my best take probably. As you say though, it is a free service.

You can, but only 10 images per hour. You'd be doing some wild shit to go over those 10 per hour.

Braindead take

My god I don't get why people bitch about Plex so much. It's fiiiine.

This must be satire

Or Blender

I played the shit out of BF2042 when it launched. Liz TGM was bae, is bae and will stay bae.

For good bed adhesion I think I have a couple pieces of advice:

• Get a PEI bed if you don't already have one. It makes a world of difference.
• If that doesn't stick well, consider getting something like this
• Make damn sure your bed is level
• Make sure the Z offset is properly set up
• If you aren't already, start by printing PLA, then move on to other filaments once that goes well.
• Make sure you have proper temperatures for both the hot end and the bed. Normal values for PLA are 210-230 on the hotend and 50-60 on the bed.

I've been back on a Battlefield 2042 'grind'. I don't think it deserves the hate it gets.

Tbh I'm a bit lost on the purpose of this