homeassistant

17195 readers

17 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

Is it possible to block/shape mmwave? (leaf.dance)

submitted 2 months ago by zerodawn@leaf.dance to c/homeassistant@lemmy.world

6 comments fedilink hide all child comments

The sensor i have let's you set zones which work width wise but not height. What i would like to do, if able, is mount the sensor waist height or a little higher and block the top and bottom of the sensor so i only have the middle 20° being used. Can this be done with foil or metal?

you are viewing a single comment's thread
view the rest of the comments

[–] mangaskahn@lemmy.world 11 points 2 months ago (2 children)

What about mounting it sideways?

[–] zerodawn@leaf.dance 2 points 2 months ago

The thought had crossed my mind but i'd still like to zone if i could.

load more comments (1 replies)