this post was submitted on 26 May 2025
283 points (96.7% liked)
Steam Deck
17736 readers
52 users here now
A place to discuss and support all things Steam Deck.
Replacement for r/steamdeck_linux.
As Lemmy doesn't have flairs yet, you can use these prefixes to indicate what type of post you have made, eg:
[Flair] My post title
The following is a list of suggested flairs:
[Discussion] - General discussion.
[Help] - A request for help or support.
[News] - News about the deck.
[PSA] - Sharing important information.
[Game] - News / info about a game on the deck.
[Update] - An update to a previous post.
[Meta] - Discussion about this community.
Some more Steam Deck specific flairs:
[Boot Screen] - Custom boot screens/videos.
[Selling] - If you are selling your deck.
These are not enforced, but they are encouraged.
Rules:
- Follow the rules of Sopuli
- Posts must be related to the Steam Deck in an obvious way.
- No piracy, there are other communities for that.
- Discussion of emulators are allowed, but no discussion on how to illegally acquire ROMs.
- This is a place of civil discussion, no trolling.
- Have fun.
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Isn’t battery adhesive the worst thing ever?
I remember fixing a few macbooks that had batteries like this. The batteries were gigantic and the adhesive was crazy strong. Dumping acetone behind them with a syringe, heat, and gently prying eventually got them out but it was quite nerve wracking. I guess you can’t dump solvents in a steam deck though
It’s so dumb. Adhesives make assembly easier but fuck over repairability. The only advantages are even distribution of pressure and vibration dampening, which are notable, but are not worth making the main wear item completely inaccessible and a nightmare to replace for the majority of people who don’t have experience with heat guns and sliding cards/thin metal to cut the stupid fucking adhesive that could’ve been replaced by a screw making the product 0.5mm thicker and 0.1g heavier (if that)
This was a chore to remove. I had to heat up the battery so much, I was really worried.
I remember batteries that had a pull tab, why can't they use those anymore
I am considering not using the adhesive that comes with the new battery, but using something a lot less adhesive.
Few drop of 91% isopropyl alcohol all around the edges of the battery and waiting a few minutes helps a lot if you're afraid of too much heat.
I thought about that, but checking the ifixit guide revealed there are holes spread around the battery tray, I was worried that any isopropyl alcohol I tried to get underneath the battery would just drain through those holes onto other hardware, potentially causing damage.
In hindsight, tough, maybe putting some IPA onto the plastic card I used to insert underneath the battery to cut through the adhesive would have worked well.
FYI, it would almost certainly cause no damage. 91% isopropyl alcohol evaporates extremely fast and with no electricity flowing it couldn't short anything.
Actually less worried about shorting something, note worried about it damaging some adhesive or protective film, or anything on the screen, really :)
That's one of my go to's when fixing phones. FYI, the plastic playing cards work great for that.
IPA (of enough concentration) is the same thing you'd use to clean the circuitry/hardware so it shouldn't cause any damage unless it dissolves with the glue and somehow that's damaging (it shouldn't be).