this post was submitted on 04 Oct 2025
161 points (97.1% liked)
homeassistant
16412 readers
140 users here now
Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.
Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation
Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It is a legit strategy.
Or just use thin enamelled copper wire connected to the sensor and tape it down where the door closes, no drilling required.
Yeah I've got a multimeter that could do it, but you would need to be careful drilling through to not hit any of the cooling jackets