Ask Electronics

3900 readers

2 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 2 years ago

MODERATORS

DavideAndrea@discuss.tchncs.de

linker3000@discuss.tchncs.de

How would I make a HVAC simulator to see what a thermostat would do if the indoor temp was 425°F (frozen pizza cooking temps) (reddthat.com)

submitted 5 days ago* (last edited 5 days ago) by batvin123@reddthat.com to c/askelectronics@discuss.tchncs.de

14 comments fedilink hide all child comments

I bought a nest gen 2 thermostat to play with a open source project that revives old nest thermostats (https://nolongerevil.com/). Since I don't want to install it into the home, because it will be a toy. I was thinking of building a test rig using a arduino or esp32 to simulate a HVAC and indoor temperature. I'm IT guy, not a HVAC guy, I think this would be a good learning project. Any suggestions?

you are viewing a single comment's thread
view the rest of the comments

[–] czardestructo@lemmy.world 1 points 4 days ago

Everyone is over thinking the hell out of this. Almost all thermostats use a cheap NTC resistor, just change the resistance so the hardware thinks its at the whacky temperature. Or you could figure out the bias voltage the system uses through the NTC then apply your own external voltage to trick the system.