this post was submitted on 28 Nov 2025
133 points (100.0% liked)

homeassistant

16912 readers
149 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
 

I've wanted to illuminate my kick plates for a long time, starting with my master bathroom, and rolling out to my secondary and kitchen

Finally started today, with a 100w 24v converter, and a gledopto ZigBee controller

Installation was easy, and the controller was quickly picked up. I previously installed a GFCI protected outlet under my sink, so I just plugged it into there.

I don't have a motion sensor yet, so it's just a timed automation:

Day: bright white, about 40% brightness Evening: warm white, about 20% brightness After 10: almoast amber, and about 1% brightness, just enough to pee by.

you are viewing a single comment's thread
view the rest of the comments
[โ€“] Smokeless7048@lemmy.world 4 points 3 hours ago (1 children)

yea, i added costco backlit/heated mirrors.

Had to run a new wire from my light fixture, but worth it,.

Pictures a bit old, i've replaced the toilet since, as the old one was leaking

[โ€“] newbeni@lemmy.world 2 points 2 hours ago

That looks really nice ๐Ÿ‘