this post was submitted on 14 Nov 2023
17 points (100.0% liked)

homeassistant

15177 readers
24 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
GreatAlbatross@feddit.uk
greatalbatross@lemmy.world
17
How do I add a cool down to an automation? (lemmy.today)
submitted 2 years ago by Buelldozer@lemmy.today to c/homeassistant@lemmy.world
11 comments fedilink hide all child comments
 

I have an automation that turns my driveway lights on when motion is detected. It normally works fairly well but it was windy last night and that caused the automation to trip endlessly as my trees and bushes were whipping around. Lights would come on, shut off 10 minutes later, then turn right back on again. It basically did this all night until I disabled the automation.

I'll do some fine tuning of the motion sensors which will help and I'm considering adding a condition to the automation where it won't trip if the wind speed is above a certain level but how can I add some kind of cool down timer to the automation to prevent it from endlessly engaging?

you are viewing a single comment's thread
view the rest of the comments
[โ€“] Lifebandit666@feddit.uk 1 points 2 years ago (1 children)

Add a door sensor to your setup? Have it trip, the lights then wait for the door to open and close before it trips again.

I mean let's face it, if someone keeps coming into your garden and doesn't knock on your doorz at nightz you don't want them to be able to see where they're going.

Just a thought.

[โ€“] Buelldozer@lemmy.today 2 points 2 years ago

That's a fair idea and I'll consider it!