homeassistant

15339 readers

4 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

Ikea switch firmware not updating (lemmy.world)

submitted 2 years ago by Oliper202020@lemmy.world to c/homeassistant@lemmy.world

8 comments fedilink hide all child comments

So i got an ikea on/off switch, i i have it connected via zigbee2mqtt, it says there is newer firmware, but when i try to update to it, it doesn't do anything, i tried pressing the buttons on it while updating, because the zigbee2mqtt documentation for the switch said that but it still doesn't update

you are viewing a single comment's thread
view the rest of the comments

[–] Oliper202020@lemmy.world 1 points 2 years ago

I went in to the Z2M OTA menu and it had an update(i just got the switch) and it just didn't show anything about it updating even after a while, so I pressed it again and it just said that it was already updating, so i waited a while more and still nothing pressed it again and it didn't say anything so I waited a bit and then restarted home assistant, but it was just the same, i dont know how to send a manual trigger message, and didn't see anything about it when i skimmed the link you sent, i dont know how to upload the logs