GenitalHurricane

joined 2 years ago
[–] GenitalHurricane@lemmy.ml 1 points 2 years ago

My opinion, from a similar situation, use the coax to pull cat6 through and replace it. Assuming it's not stapled down or too tight. In a previous home I rented I didn't want to run cable knowing I would only be there a few years so I picked up MOCA boxes; lets you run eth over coax. I connected a switch in the bedroom for a steam box and smart TV to the router downstairs using this and worked fairly well but never did intensive bandwidth tests. Might be worth looking at.

[–] GenitalHurricane@lemmy.ml 2 points 2 years ago

This is in my top 10 best games of all time, highly recommend after several hundred hours over the years. My group of friends plays all sorts of multiplayer games together and we always end up coming back for a dungeon or two when we don't know what to play

[–] GenitalHurricane@lemmy.ml 1 points 2 years ago

This is the correct comment

[–] GenitalHurricane@lemmy.ml 2 points 2 years ago (1 children)

Is it new? Has it always done this? Have you used any additional wiring harness included? Am not an expert but want to try to help. I experienced this years ago after installing an Ecobee without the additional wiring harness which provides power for the ecobee to run correctly. Each time the furnace would change states the ecobee would reboot. Never happened when using the AC. Something about a "c wire" missing from older houses and needing the additional wiring kit.