3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
view the rest of the comments
Hummm, lots of good suggestions. Honestly what I would do is get something cheap that works. Then learn what your needs are.
3D Printers are a tool, and like all tools there are cheap ones which break in 30 seconds if you are actually using them. And tools which will last a lifetime but cost a fortune.
As someone who started with the (at the time) budget printer, the MonoPrice Select Mini. My suggestions are are follows.
200mm x 200mm x 200mm heated bed. This is common for printers who are clones of the i3 and isn’t hard to get cheap.
Doesn’t require proprietary software or can use open source software. Back in the day some printers would only take gcode from their proprietary slicer software. Flashforge comes to mind. But just check if what you are buying has a profile (even community made) for you slicer. Prusa and Cura are the 2 popular ones everything else is based on.
Automatic bed levelling. Whether it’s magnets like a MK3 or a touch sensor like the ender 3. So long as it can mesh bed level out of the box it’s fine. So long have I tried to dial in my printer only for it to need to be dialled in again.
Finally check Amazon or other sites for replacement parts. This is a machine and parts wear down. You don’t need to replace everything, but belts hot end assemblies, print beds and sensors are a going to break and need replacing.
For my recommendation is for a ender 3 s1 or the elegoo Neptune as they meet my spec and look fine. Though triple check with reviews