Steam Hardware
A place to discuss and support all Steam Hardware, including Steam Deck, Steam Machine, Steam Frame, and SteamOS in general.
As Lemmy doesn't have flairs yet, you can use these prefixes to indicate what type of post you have made, eg:
[Flair] My post title
The following is a list of suggested flairs:
[Deck] - Steam Deck related.
[Machine] - Steam Machine related.
[Frame] - Steam Frame related.
[Discussion] - General discussion.
[Help] - A request for help or support.
[News] - News about the deck.
[PSA] - Sharing important information.
[Game] - News / info about a game on the deck.
[Update] - An update to a previous post.
[Meta] - Discussion about this community.
If your post is only relevant to one hardware device (Deck/Machine/Frame/etc) please specify which one as part of the title or by using a device flair.
These are not enforced, but they are encouraged.
Rules:
- Follow the rules of Sopuli
- Posts must be related to Steam Hardware or Steam OS in an obvious way.
- No piracy, there are other communities for that.
- Discussion of emulators are allowed, but no discussion on how to illegally acquire ROMs.
- This is a place of civil discussion, no trolling.
- Have fun.
view the rest of the comments
My hope after seeing that the joysticks themselves look like they can be removed from the main board is that the touchpads can be relocated to the top without too much hassle and put into a 3D printed top shell made by the community. So if that were possible what I'd probably do is pop off the XYAB, dpad, and board holding the joystick so the touchpad can be moved up to make the touchpads comfortable for primary use.
And then I'd rely on the back buttons and set up a dpad modeshift on a right pad click to enable edge and center clicks, so I wouldn't miss the absence of the other inputs too much. I also use touchpad for movement where I'll often set outer ring to sprint and map crouch/slide/dash on touchpad click, so cuts down on needed inputs further.
So that's my hope that modifying the new Steam Controller for touchpad users will be as simple as 3d printing a shell and opening the controller and not require further things like soldering.