3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
view the rest of the comments
Clear coat it or the layer lines will pick up all the gamer gunk(dead skin and oils).
Frankly, a few dozen passes with 120-220 grit, (with the grain) followed by a quick acetone wipe down (picks up any particulate) and then a couple light coats of gloss varnish (spray; 8-10" away, just enough to begin saturating the surface) varnish before waiting 24hrs+ (ie. gas off) to box it up... is the pro move here. 🫶🏼🤓
I try and avoid sanding plastic as much as possible even if it's PLA
Just do it outside then.
Or just do it in the garage. Not to devalue your point (because you aren't wrong either, the dust isn't probably healthy), but honestly thinking back over all the shady things that have gone down in my garage over the years, sanding a bit of PLA wouldn't even nick the surface.
Lmao I recently spilled a liter of hydrochloric acid in my garage.
I get that but creating microplastics to get a smooth finish on an Xbox controller faceplate doesn't seem like a good move to me.
Uh... That's where you're drawing the line? That very specific, all but arbitrary point along a path already littered with ethical failures? Really? 😅 I mean, you do you. 🙇🏼♂️🥲
One of these days, your perspective might change a little, heh —but try not to get dragged down by the myriad crimes against humanity inherent in plastics, et al industries... 🤷🏼♂️
Change what you can, working from yourself outward. Use PPE, sand your plastic gadgets, do a good job, bring joy into the world with your efforts. ✊🏼🫶🏼
I've never tried it but this method looks interesting. I wonder if it would work with clear primer instead of paint.
https://www.instructables.com/Easy-Way-to-Smooth-PLA-No-Sanding-No-Chemicals/
FWIW, that's essentially just gap-filling with more steps and increased procedural risk; the varnish (polyurethane) is already a component of the spray paint, and the steps as described leave an incredible amount of room for failure on multiple points. It's reinventing the wheel and boxing it up as a lifehack. 🤌🏼🫣
Trim, sand*, clean, paint*, seal*, bring joy. Simple as.
*as needed