I ordered a MiniTools test clip to start experimenting with flashing EEPROMs. There was no information on the retailer's website regarding the width of the pins. This is what I got:
I asked MiniTools if they have any solution to this. They said "no". I then realized that this clip was probably meant for soldering. Which I haven't had the energy to learn yet.
I ended up buying the expensive Pomodo one.
The flashing went well.
If that is the SO-14 clip, it is 1.27mm or 1/20in. There are small PCBs to convert SO-14 to 2.54mm / 1/10in raster. Simple soldering job, but if you don't have the means, look for a repair cafe.
Thank you for teaching me that! :D
We don't have repair cafes where I'm from :(
However! I have been thinking about learning how to solder lately! :) Some basic equipment shouldn't cost too much, right? And with the world wide web at my fingertips, what could go wrong. :D ๐ฅ๐ฌ๐ฉ (couldn't find a "solder" emoji, so I did "melt microscopic metal")
Depends... I started over 40 years ago with a simple, unregulated iron that was in the 5 dollar range. My current one is a Weller and costs about 300. And that is a cheap one.
Before you start soldering electronics, though, I'd start with soldering the "cube" from straight wires, then proceed to solder simple parts to perfboards.