Some other pics, this was after cleaning up a little with the chisel too. I was aiming for about 2-2.5 degrees. Would be nice to have something better right off the saw (or other method).
this post was submitted on 27 Jun 2023
8 points (90.0% liked)
Woodworking
7528 readers
27 users here now
A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
What did you use? I'd use a table saw with an angle and cut along a piece of wood, then chop them up with a miter saw.