Dagamant

Love a good Dendrogaster post

50 is a lot my guy. Not to mention other communities where they received a positive reaction.

Also, the other set like this got almost a hundred where I usually get around 50

It’s a bit of a crapshoot. The weight of the black vs the colored with additives is very minuscule. It might show in a float test but in normal use not so much. If I used something like mica powder for a portion of the die that might add more weight to a side. White pigments tend to be a bit heavy so I use them sparingly and make sure they are well mixed. I do try to avoid additives that sink. I have a box of shame for glitters and flakes that sink because they would throw off the balance slightly.

The biggest factor that would throw off weight is bubbles and I do a lot to prevent those. The resin goes through a vacuum chamber with vibration after mixing and the dice cure in a pressure pot to eliminate bubbles completely.

This is not a good move. Some narrators add a lot to the book with their tone and inflection while AI just doesn’t do that. It can’t understand the story and add subtle emotion to its voice.

Is that price at full retail price or cost of parts. Either way, sounds like someone misjudged the market by a lot and needs to be ejected from their CEO role.

That snapping turtle will eat the baby red eared slider. Those turtles arent related at all.

I make these with little ESP32 boards. Selling them has made me more money than crypto mining ever did. People love to waste money on stupid things.

Your English is very good, is it commonly spoken there or do you have another reason for using it? If you had to estimate, how often do people speak Greenlandic, Danish, or English in their daily lives? What about the languages used in written media?

Do you ever go fishing? What are the shores like?

He is like a pustule. The disease is underneath and around the area but squeezing it empty will be a huge relief and afterward the healing will accelerate

That’s pre polish. I’m not using this one because I screwed up the measurement and the numbers font is too tight in places. Next print is much larger and has a different font for the numbers. The big one is almost 80mm face to face. The largest I can make it with the software. The others are the other sizes for the people who are not his wife. The middle one is larger than the one in the original picture but not by much.

It definitely won’t be easy. He was my best friend for almost 30 years. He introduced me to tabletop games when we met and he had a huge collection of games. I think he would appreciate the resting place and being included in games. The last few years he wasn’t able to do much other than GM and he put everything he had into it.

The plan is to do it differently in each die. The 100mm has a partial blank that will act as a stand for his items. That blank will be made from his ashes. The 60mm will do something similar but instead of items it will have a lock of his hair on the partial blank. The standard sets will be a swirl of his favorite colors and his ashes.

I talked to someone else who makes resin memorial items and they warned me about ashes sinking and not being grey when encased and my plan is to put some of the ashes in an alcohol bath and stir it up, let it sit for a few minutes, and pour the ash that hasn’t settles into a drying dish so I can collect the ultra fine ash to use for the standard sets to help prevent it from sinking. That aside, the color won’t be a huge issue.