Einstein

Im only familiar with Cura. Cura has wall settings I think you are looking for to fix your problem. I had similar issues with a print. Used settings like wall transition length, wall distribution count, wall transitioning threshold angle, wall transitioning filter margin, and minimum wall line width. I was able to fill in tight corners, just took a little while dialing in the settings.

'Jewish Space Lasers' -MTG

Why is it always projection with these people?

Lol called it. Grifters gonna grift.

It's probably dropped low enough now for him and his goonies to buy everything up just in time for the tariffs to get reversed this week. At this point I'll be shocked if they don't reverse the tariffs this week.

Wish we would eliminate billionaires instead. Fastest way to make improvements in this world.

I think fungi will take over the world. As time goes on, more of them become virulent and the already virulent become more virulent. Don't think humans will be able to keep up in the long term.

We're at the it's too late stage for that though :(

It's your opinion that smells like shit.

With hopes and prayers.

I wonder how long it'll be before they decide to deport Rubio.

Fuck the fascist GOP

The wealth gap is getting worse at an exponential rate. How long until we all bust out the guillotines?