Scafir

I do not know if they are open to the public per se, but it seemed to be something they do quite regularly. Concerning the material, they say on their site that it is a "polymer". On this page they go quickly over how the measurements work.

I was actually not visiting sensirion, but lumiphase. A smaller company they are investing in which does optical chips. It's interesting stuff, they are also depositing unusual materials on the silicon wafer to make their chips work.

Thanks! I recently was in the headquarters/production facilities of Sensiron which interestingly are located near Zurich in Switzerland. It's quite rare to see production of IC's in this country. The "magic sauce" of the sht40 and friends is the deposition of a certain matieral (can't remember which one) on top of the classic silicon die.

Hey! Props to you for trying something new. While the through hole components look OK, soldering large gauge wire can be quite tricky, especially if the soldering iron is not powerful. What soldering iron do you use? In these cases especially, it is important to wick the wire first, wick the soldering pad and finally assemble the two. Raising the iron temperature for this can also be useful (I sometimes use 400° or a bit higher). It is counter intuitive, but hotter iron means quicker soldering job, and less heat in the surrounding area (e.g cable's insulator)

The green and orange colors are quite typical of the phoenix contacts brand. It's not a perfect match, but this model is very close: https://www.phoenixcontact.com/en-us/products/printed-circuit-board-terminal-sptaf-1-7-35-il-1861988

I have one of these right in front of me (SPEC-3). They sure look very nice, but mine would need some work to properly work again :( Time's not kind on electronics

Looks great!

If your are looking for pur aesthetics, I would recommend trimming the resistors/leds, and bending their leads before putting them on.

If you'd like some inspiration this guy has some of the best looking hand crafted electronics I've ever seen.

I don't know so much about EGS, but probably some of the following (most of which I don't use very often, I hope I recall correctly)

• Refunds
• Family sharing of games
• Sharing games for other local users
• Being able to lend games
• Remote Play (with friends)
• Remote Play (stream for a local machine)
• Linux support through proton
• probably more?

Freecad is getting more and more attention. When version 1.0 releases (soon), it will be something worth checking out, but there is still work to do.

It depends on the use cases. I don't like how this post makes it look like the "Linux" alternatives are drop in, one-to-one replacement. Inkscape has been immensely useful to me, but for professional work, it might not be a reasonable replacement.

What do you mean exactly by organic maps editing tools? I was using organic maps before to add businesses, but now StreetComplete can also do that (and more!). I sometimes use Vespucci because it is very powerful, but it's a bit of a pain to use.

Actually, a least some cars (probably more than you think)/have some sort of "emergency" breaking signal, which often result in the usual breaking signal blinking for a while. You need to seriously slam the brakes to see it though. E.g: https://m.youtube.com/watch?v=j_osu1WgGMU

There is also a nice technology connection video talking about braking lights for electric cars and in general, which can be dangerous.

It was always under my nose, but I never realised it was there. Thanks for the tip!