Summer I really make sure they’re in vac bags with indicating desiccant. Winter not so worried. I used to just not care but since getting an X1C with ams I’ve had a number of rolls of pla snap inside and trying to clear that out is annoying. Haven’t really had an issue sense although I have some esun pla+ that is incredibly brittle and will snap just looking at it.
dawnerd
joined 2 years ago
Hmm kinda like what they did before. It worked. I knew I was going to get one and the community built a spreadsheet tracking estimates dates.
No because it’s not decentralized. That’s like saying Twitter is decentralized because it’s microservices communicate over https.
It’s funny how you can build out a grid and find out it’s all off slightly. They’re doing some rounding somewhere and it gets clearer the further out from the start of a 90 degree you get
That overlay has such bad contrast it’s hard to see what’s going on. Big accessibility issue.
Really same reason all these companies making dramatic changes. Rips the bandaid off and lets them roll back to what they actually wanted while looking like they listen. Some are executed better than others. See Deltas medallion change for another example.
It’d be fun to mess around with if it wasn’t 12-18k for the setup.
More surprised you managed to post a negative review. Every time I do it fails amazons community guidelines check or get removed a few days after.
This is actually ewaste. The normal pencils have been on sale fairly often for 99 bucks and the price difference isn’t really enough so all they’re doing is making trash in an attempt to lure people into paying the small amount more for the better version.
This has been an issue for years though. Guessing either they made it worse or people just now noticing.
This IS the same guy that kept raising the price of FSD despite not delivering on promises.
view more: next ›
Should go after anywhere that has perpetual agreements including the ones that try to get around it by the last living clause or 100 years etc. I don’t know a good solution but I’m sure they can put limits and carve outs where needed.