hisbaan

Before I sold my FC660C, I took it apart and lubed the sliders a few times with trybosis 3204. It was my first time taking apart a keyboard and wasn't particularly difficult and the stabilizer keys are really just wider regular topre keys. There is a wire, but it's inside the key instead of over top like cherry. A good set of tweezers is all you need. There's a good video by Taeha Types about lubing an HHKB which was not all that different. I'd say the most tedious thing about it was just how many screws there are holding the PCB to the plate

A few things to watch out for:

• be careful about the ribbon cable that goes from the main board to the daughter board that has the usb port on it
• try and keep the domes from separating from the PCB. there shouldn't be any reason to remove them and they're held in place with some sort of adhesive. I've heard if you take them out then it's a pain getting it all back together.
• if you take the sliders apart you may break some plastic tabs on them, but that's normal so don't worry (see any video about lubing topre)

Feel free to reach out if you have any specific questions! :)

I may be wrong but I believe that all of the systemd programs are decoupled. You can run the systemd init system without any resolved or networkd. They just happen to be used by default on a lot of distros.

Mechmarket might be a good place to check

No worries :)

Here's what I found on the readme on the nvim repo

Catppuccin is excellent in terms of features, plugin support, and customizing highlight groups/palette colours

I find it much more convenient to press a button that's already under my thumb and then press a button that's already under my middle finger (for example) to get a symbol I want than move my hands from their typing position to get a symbol. It takes some time to adjust but I'm at about the same speed I was on a standard keyboard while using a corne (like the lily58 but with no numrow and one fewer thumb buttons per side)

Also space is right under your thumb as well, and shift can be in its normal place

It's technically a unibody split (notice that t and y are 2u apart) so that qualifies it as ergonomic according to the sidebar if I'm interpreting it correctly

I haven't fact checked this at all but apparently lowprokb.ca is working with Kailh on some choc v1 compatible silent switches which could potentially be used in those boards. Not sure when they'll be available though

Take a look at stuff from keeb.io, most of their split offerings can run with either side as the 'host' as far as I know

I'm able to sort communities by new, you just have to get the header to show up by scrolling a bit. It might be hidden if you have hide on scroll on

I think you might like the design of the typeractive.xyz corne where the put the battery under the MCU and have headers to give space for it

There are custom themes if you dig a little more in that menu