My experience is that Zigbee's range is fine, but it is highly susceptible to interference/electrical wires/water pipes that might be in walls. I put my Conoff dongle on a 12 ft USB extension (my HA Raspberry Pi is right next to my router, modem, and home server). Then, as I was having issues with devices staying connected, I added routers. I tried to place them so they had clear line of sight with each other (or the dongle), or only through one wall. After that, I've had no problems. It ended up being about one per room. Ikea's smart plugs are cheap and I use them only as routers.
phrogpilot73
joined 2 years ago
Do you have any zigbee routers (mains powered devices) scattered around your house? I had the same problem, then I strategically placed a bunch of smart plugs throughout my house. Haven't had any problems since.
If you want to up your pasta game even more, try what's in this article: https://www.seriouseats.com/the-right-way-to-sauce-pasta
I decided to try it once. I told myself it would only be once. Now it's the only way I sauce pasta, and it's totally worth the little extra work.
I'm with you on this. The desktop app isn't connecting now, but I can log in via the web app and it appears to work.
Only downside is it's not a very robust surge protector. It's 820 joules if I remember correctly. We have one installed for our all in one washer dryer and fridge. No issues so far.
The Eaton TR5260 has a line/load side and their technical documentation says it provides downstream protection for the other outlets.
While I don't have the number of devices you do, I can add two observations:
Kwikset Zigbee Door Locks have been rock solid since the day I installed them. No issues dropping off the network. The only downside is occasional delay in reporting state (locked/unlocked) to HA. Getting it to respond to a command to lock/unlock is near instantaneous.
Ikea Zigbee devices have also been rock solid. The only issue is that none of them seem to report battery level reliably. Other than that, there are zero issues.
SV08/ voron for the folks that like to tinker (and value not living in a walled garden, Sovol's hot end/ nozzles not withstanding).
I would call the SV08 hot end/nozzles proprietary-ish. They still published everything on github, which enabled the community to design a modified heat sink (that I got printed on PCBWay). The updated heat sink allows you to swap in an E3D Revo nozzle. That wouldn't be possible if it was truly proprietary.
The enclosure for my SV08 arrives today. Looks like my first ABS print is decided. I was trying to figure out how to cleanly/neatly arrange a cable on the dash (from the break controller display) so it doesn't block a couple switches and the stereo. Thanks for the design!
GTA5 still works, just not online/multi-player. Story mode works.
You too, huh? Thank God for backups.
Are there any other home roasters in here?
view more: next ›
SteamVR + ALVR worked on my quest, and then I tried WiVRn. Fewer options to tweak than ALVR, but it's all in one and has been rock solid since I started using it.